Enterasys Networks 6H302-48 manual

Page 3

NOTICE

Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made.

The hardware, firmware, or software described in this document is subject to change without notice.

IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN THEM, EVEN IF ENTERASYS NETWORKS HAS BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE POSSIBILITY OF SUCH DAMAGES.

Enterasys Networks, Inc.

35 Industrial Way

Rochester, NH 03867

2002 by Enterasys Networks, Inc. All Rights Reserved Printed in the United States of America.

Order Number: 9033387-05 October 2002

LANVIEW is a registered trademark and ENTERASYS NETWORKS, NETSIGHT, SMARTSWITCH, MATRIX, WEBVIEW, and any logos associated therewith, are trademarks of Enterasys Networks, Inc. in the United States and other countries.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

Image 3
Contents 6H302-48 and 6H303-48 Fast Ethernet User’s Guide Page Page Class a ITE Notice FCC NoticeIndustry Canada Notice Vcci NoticeEnterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Index Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpImportant Notice Introduction6H302-48 and 6H303-48 Modules Smarttrunk ConnectivityRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONRemote Monitoring Rmon Broadcast SuppressionPORT/VLAN Redirect Functions Flow Control Traffic Rate LimitingDistributed Chassis Management Garp Switch OperationManagement Switching OptionsStandards Compatibility Lanview Diagnostic LEDsSmarttrunk Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Installing Optional Flash Upgrade Installing the Module Into the Matrix E7 ChassisUnpacking the Module Installation Installing a Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing a Module into the 6C105 Chassis Connecting UTP Cables to the 6H302-48 Connecting to the NetworkGroup Select Connecting UTP Cables to the 6H303-48 Connecting a Twisted Pair Segment to the 6H303-48 Completing the Installation Page Using Lanview TroubleshootingLanview LEDs both modules LED LED Troubleshooting Checklist Troubleshooting Checklist6Troubleshooting Reset Button both modules Using the Reset ButtonPage 6H302-48 / 6H303-48 Specifications Specifications6H302-48 Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsOnly qualified personnel should change switch settings Setting the Mode SwitchesMode Switch Bank Settings and Options B-3 Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2