Enterasys Networks 6H302-48 manual

Page 6

5.UNITED STATES GOVERNMENT RESTRICTED RIGHTS. The enclosed Product (i) was developed solely at private expense; (ii) contains “restricted computer software” submitted with restricted rights in accordance with section 52.227-19 (a) through (d) of the Commercial Computer Software-Restricted Rights Clause and its successors, and (iii) in all respects is proprietary data belonging to Enterasys and/or its suppliers. For Department of Defense units, the Product is considered commercial computer software in accordance with DFARS section 227.7202-3 and its successors, and use, duplication, or disclosure by the Government is subject to restrictions set forth herein.

6.EXCLUSION OF WARRANTY. Except as may be specifically provided by Enterasys in writing, Enterasys makes no warranty, expressed or implied, concerning the Program (including its documentation and media).

ENTERASYS DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY ENTERASYS IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANYING HARDWARE.

7.NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL ENTERASYS OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS, PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THIS ENTERASYS PRODUCT, EVEN IF ENTERASYS HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, OR IN THE DURATION OR LIMITATION OF IMPLIED WARRANTIES IN SOME INSTANCES, THE ABOVE LIMITATION AND EXCLUSIONS MAY NOT APPLY TO YOU.

Image 6
Contents 6H302-48 and 6H303-48 Fast Ethernet User’s Guide Page Page Vcci Notice FCC NoticeIndustry Canada Notice Class a ITE NoticeEnterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Index Figures Tables Using this Guide About This GuideStructure of this Guide Related DocumentsDocument Conventions Guide uses the following conventionsGetting Help Your email addressIntroduction Important Notice6H302-48 and 6H303-48 Modules HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION ConnectivityRuntime IP Address Discovery SmarttrunkRemote Monitoring Rmon Broadcast SuppressionPORT/VLAN Redirect Functions Traffic Rate Limiting Flow ControlGarp Switch Operation Distributed Chassis ManagementSwitching Options ManagementLanview Diagnostic LEDs Standards CompatibilitySmarttrunk Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Installing Optional Flash Upgrade Installing the Module Into the Matrix E7 ChassisUnpacking the Module Installation Installing a Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing a Module into the 6C105 Chassis Connecting to the Network Connecting UTP Cables to the 6H302-48Group Select Connecting UTP Cables to the 6H303-48 Connecting a Twisted Pair Segment to the 6H303-48 Completing the Installation Page Troubleshooting Using LanviewLanview LEDs both modules LED LED Troubleshooting Checklist Troubleshooting Checklist6Troubleshooting Using the Reset Button Reset Button both modulesPage Specifications 6H302-48 / 6H303-48 Specifications6H302-48 COM Port Pinout Assignments Regulatory CompliancePage Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Only qualified personnel should change switch settingsMode Switch Bank Settings and Options B-3 Flash Upgrade Figure B-2shows the location of the Flash moduleInstalling the Flash Module Page Index NumericsIndex-2