Enterasys Networks 6H302-48 manual Completing the Installation

Page 37

Completing the Installation

b.Verify that the RJ21 connectors on the twisted pair segment have the proper pinouts and check the cable for continuity.

c.Check that the twisted pair connection meets the specifications in the Cabling Guide.

If a link is not established, contact Enterasys Networks. Refer to “Getting Help” in About This Guide for details.

5.Repeat steps 1 through 5, above, until all RJ21 connections are made.

3.6COMPLETING THE INSTALLATION

After installing the module and making the connections to the network, proceed as follows:

1.If the chassis is installed in a rack that has strain-relief brackets, secure the cables by running the cables along the strain-relief bracket and tying them to the bracket using cable ties.

2.The module is now ready to be configured through Local Management. Refer to the appropriate Local Management User’s Guide for information on how to access and use Local Management. For details on how to get manuals, refer to the “Related Documents” section in About This Guide.

Installation 3-11

Image 37

Contents 6H302-48 and 6H303-48 Fast Ethernet User’s Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Class a ITE NoticeEnterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Index Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpImportant Notice Introduction6H302-48 and 6H303-48 Modules Runtime IP Address Discovery ConnectivityHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION SmarttrunkBroadcast Suppression Remote Monitoring RmonPORT/VLAN Redirect Functions Flow Control Traffic Rate LimitingDistributed Chassis Management Garp Switch OperationManagement Switching OptionsStandards Compatibility Lanview Diagnostic LEDsNetwork Requirements Smarttrunk Feature10BASE-T Network 100BASE-TX Network Installation Installing the Module Into the Matrix E7 Chassis Installing Optional Flash UpgradeUnpacking the Module Installation Installing a Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing a Module into the 6C105 Chassis Connecting UTP Cables to the 6H302-48 Connecting to the NetworkGroup Select Connecting UTP Cables to the 6H303-48 Connecting a Twisted Pair Segment to the 6H303-48 Completing the Installation Page Using Lanview TroubleshootingLanview LEDs both modules LED LED Troubleshooting Checklist Troubleshooting Checklist6Troubleshooting Reset Button both modules Using the Reset ButtonPage 6H302-48 / 6H303-48 Specifications Specifications6H302-48 Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsOnly qualified personnel should change switch settings Setting the Mode SwitchesMode Switch Bank Settings and Options B-3 Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2