Enterasys Networks 6H302-48 manual Unpacking the Module, Installing Optional Flash Upgrade

Unpacking the Module

3.1UNPACKING THE MODULE

Unpack the module as follows:

1.Open the box and remove the packing material protecting the module.

2.Verify the contents of the carton as listed in Table 3-1.

Table 3-1 Contents of Module Carton

Item	Quantity
One module, either the 6H302-48 or the 6H303-48	1
Antistatic Wrist Strap	1
Manual Accessory Kit	1

3.Remove the tape seal on the non-conductive bag to remove the module.

4.Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys Networks if there are any signs of damage. Refer to “Getting Help” for details.

3.2INSTALLING OPTIONAL FLASH UPGRADE

NOTE: Install any optional equipment before proceeding to Section 3.3.

If the module is to be installed with an optional FLASH upgrade, refer to Appendix B for complete installation instructions.

3.3INSTALLING THE MODULE INTO THE MATRIX E7 CHASSIS

CAUTION: Failure to observe static safety precautions could cause damage to the module. Follow static safety handling rules and wear the antistatic wrist strap provided with the Matrix E7 chassis.

Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or components can cause damage.

The module can be installed in any of the slots that are available.

3-2Installation