Enterasys Networks 6H302-48 manual Using the Reset Button, Reset Button both modules

Using the RESET Button

4.3USING THE RESET BUTTON

The RESET button shown in Figure 4-2resets and re-initializes the module.

CAUTION: Pressing the RESET button resets the device, and all current switching being performed by the module is halted. A network downtime of up to two minutes will result from this action for any devices connected to the module.

Figure 4-2 RESET Button (both modules)

FAST ENET

6H302-48

RESET Button

RESET

COM

1X CPU

GROUP

SELECT

G
R	GROUPGROUP
O
U
P

To reset the module processor, press and release the RESET button. The module goes through a reset process for approximately 60 seconds. Additional downtime may result as the module reenters the network.

NOTE: Pressing the RESET button while the module is already in reset mode is not recommended. If the RESET button is pressed while the module is in reset mode, the module will enter an extended diagnostic procedure, which is unnecessary for normal operation. This extended diagnostic procedure takes longer than one minute to complete.

Troubleshooting 4-7