Enterasys Networks 6H302-48 manual Installing the Flash Module

Page 55

FLASH Upgrade

B.3.2 Installing the FLASH Module

CAUTION: Observe all antistatic precautions when handling sensitive electronic equipment.

To install a FLASH module, refer to Figure B-3and proceed as follows:

1.With the FLASH module oriented as shown in Figure B-3, insert the FLASH module down between the connector.

2.Pivot the FLASH module downward so the connector clips align with the two side notches of the FLASH module and the connector clips lock the FLASH module into place.

Figure B-3 Installing the FLASH

2

Flash

Connector Clip

1

Clip

3387_11

Mode Switch Bank Settings and Options B-5

Image 55

Contents 6H302-48 and 6H303-48 Fast Ethernet User’s Guide Page Page Class a ITE Notice FCC NoticeIndustry Canada Notice Vcci NoticeEnterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Index Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpImportant Notice Introduction6H302-48 and 6H303-48 Modules Smarttrunk ConnectivityRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONBroadcast Suppression Remote Monitoring RmonPORT/VLAN Redirect Functions Flow Control Traffic Rate LimitingDistributed Chassis Management Garp Switch OperationManagement Switching OptionsStandards Compatibility Lanview Diagnostic LEDsNetwork Requirements Smarttrunk Feature10BASE-T Network 100BASE-TX Network Installation Installing the Module Into the Matrix E7 Chassis Installing Optional Flash UpgradeUnpacking the Module Installation Installing a Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing a Module into the 6C105 Chassis Connecting UTP Cables to the 6H302-48 Connecting to the NetworkGroup Select Connecting UTP Cables to the 6H303-48 Connecting a Twisted Pair Segment to the 6H303-48 Completing the Installation Page Using Lanview TroubleshootingLanview LEDs both modules LED LED Troubleshooting Checklist Troubleshooting Checklist6Troubleshooting Reset Button both modules Using the Reset ButtonPage 6H302-48 / 6H303-48 Specifications Specifications6H302-48 Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsOnly qualified personnel should change switch settings Setting the Mode SwitchesMode Switch Bank Settings and Options B-3 Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2