Enterasys Networks 6H302-48 manual Installation

Page 27

3

Installation

ELECTRICAL HAZARD: Only qualified personnel should install the module.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to the supported features and operation documented in this guide.

This chapter provides the instructions to install the 6H302-48 or 6H303-48 module. A Phillips screwdriver is required to install options into the module. Follow the order of the sections listed below to correctly install the module.

•Unpacking the Module (Section 3.1)

•Installing Options (Section 3.2)

•Installing the Module into the Matrix E7 Chassis (Section 3.3)

•Installing the Module into the SmartSwitch 6000 (6C105) Chassis (Section 3.4)

•Connecting to the Network (Section 3.5)

•Completing the Installation (Section 3.6)

Image 27

Contents 6H302-48 and 6H303-48 Fast Ethernet User’s Guide Page Page Class a ITE Notice FCC NoticeIndustry Canada Notice Vcci NoticeEnterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Index Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpImportant Notice Introduction6H302-48 and 6H303-48 Modules Smarttrunk ConnectivityRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONRemote Monitoring Rmon Broadcast SuppressionPORT/VLAN Redirect Functions Flow Control Traffic Rate LimitingDistributed Chassis Management Garp Switch OperationManagement Switching OptionsStandards Compatibility Lanview Diagnostic LEDsSmarttrunk Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Installing Optional Flash Upgrade Installing the Module Into the Matrix E7 ChassisUnpacking the Module Installation Installing a Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing a Module into the 6C105 Chassis Connecting UTP Cables to the 6H302-48 Connecting to the NetworkGroup Select Connecting UTP Cables to the 6H303-48 Connecting a Twisted Pair Segment to the 6H303-48 Completing the Installation Page Using Lanview TroubleshootingLanview LEDs both modules LED LED Troubleshooting Checklist Troubleshooting Checklist6Troubleshooting Reset Button both modules Using the Reset ButtonPage 6H302-48 / 6H303-48 Specifications Specifications6H302-48 Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsOnly qualified personnel should change switch settings Setting the Mode SwitchesMode Switch Bank Settings and Options B-3 Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2