Enterasys Networks 6H302-48 FCC Notice, Industry Canada Notice, Vcci Notice, Class a ITE Notice

Page 4

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

INDUSTRY CANADA NOTICE

This digital apparatus does not exceed the class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pa s de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioé lectrique édicté pa r le ministère des Communications du Canada.

VCCI NOTICE

This is a class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

CLASS A ITE NOTICE

WARNING: This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Image 4
Contents 6H302-48 and 6H303-48 Fast Ethernet User’s Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Class a ITE NoticeEnterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Index Figures Tables Using this Guide About This GuideStructure of this Guide Related DocumentsDocument Conventions Guide uses the following conventionsGetting Help Your email addressIntroduction Important Notice6H302-48 and 6H303-48 Modules Connectivity Runtime IP Address DiscoveryHALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION SmarttrunkBroadcast Suppression Remote Monitoring RmonPORT/VLAN Redirect Functions Traffic Rate Limiting Flow ControlGarp Switch Operation Distributed Chassis ManagementSwitching Options ManagementLanview Diagnostic LEDs Standards CompatibilityNetwork Requirements Smarttrunk Feature10BASE-T Network 100BASE-TX Network Installation Installing the Module Into the Matrix E7 Chassis Installing Optional Flash UpgradeUnpacking the Module Installation Installing a Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing a Module into the 6C105 Chassis Connecting to the Network Connecting UTP Cables to the 6H302-48Group Select Connecting UTP Cables to the 6H303-48 Connecting a Twisted Pair Segment to the 6H303-48 Completing the Installation Page Troubleshooting Using LanviewLanview LEDs both modules LED LED Troubleshooting Checklist Troubleshooting Checklist6Troubleshooting Using the Reset Button Reset Button both modulesPage Specifications 6H302-48 / 6H303-48 Specifications6H302-48 COM Port Pinout Assignments Regulatory CompliancePage Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Only qualified personnel should change switch settingsMode Switch Bank Settings and Options B-3 Flash Upgrade Figure B-2shows the location of the Flash moduleInstalling the Flash Module Page Index NumericsIndex-2