Enterasys Networks manual 6H302-48 / 6H303-48 Specifications

Page 47

A

Specifications

This appendix provides operating specifications for the 6H302-48 and 6H303-48 modules. Enterasys Networks reserves the right to change the specifications at any time without notice. If not specified by module name, the statistics are the same for both modules.

A.1 6H302-48 / 6H303-48 SPECIFICATIONS

Table A-1provides the processors and memory, physical properties, environmental module specifications, and I/O ports for the 6H302-48 and 6H303-48 modules.

Table A-1 6H302-48 / 6H303-48 Specifications

Item	Specification

Processors/Memory

Processors:	Intel i960 HT RISC processor Power PC
Dynamic Random Access
Memory (DRAM):	20 MB
FLASH Memory:	8 MB expandable to 16 MB
Shared Memory:	4 MB

Physical Properties

Dimensions:	46.43 H x 6.05 W x 29.51 D (cm)
	18.28 H x 2.38 W x 11.62 D (in)
Approximate Weight (Unit):	2.04 kg (4.5 lb)
MTBF (Predicted):
6H302-48	176,149 hours
6H303-48	183,945 hours

Specifications A-1

Image 47

Contents 6H302-48 and 6H303-48 Fast Ethernet User’s Guide Page Page Class a ITE Notice FCC NoticeIndustry Canada Notice Vcci NoticeEnterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Index Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsYour email address Getting HelpImportant Notice Introduction6H302-48 and 6H303-48 Modules Smarttrunk ConnectivityRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONPORT/VLAN Redirect Functions Remote Monitoring RmonBroadcast Suppression Flow Control Traffic Rate LimitingDistributed Chassis Management Garp Switch OperationManagement Switching OptionsStandards Compatibility Lanview Diagnostic LEDs10BASE-T Network Smarttrunk FeatureNetwork Requirements 100BASE-TX Network Installation Unpacking the Module Installing Optional Flash UpgradeInstalling the Module Into the Matrix E7 Chassis Installation Installing a Module into the Matrix E7 Chassis Installing the Module Into the 6C105 Chassis Installing a Module into the 6C105 Chassis Connecting UTP Cables to the 6H302-48 Connecting to the NetworkGroup Select Connecting UTP Cables to the 6H303-48 Connecting a Twisted Pair Segment to the 6H303-48 Completing the Installation Page Using Lanview TroubleshootingLanview LEDs both modules LED LED Troubleshooting Checklist Troubleshooting Checklist6Troubleshooting Reset Button both modules Using the Reset ButtonPage 6H302-48 / 6H303-48 Specifications Specifications6H302-48 Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Mode Switch Bank Settings and OptionsOnly qualified personnel should change switch settings Setting the Mode SwitchesMode Switch Bank Settings and Options B-3 Figure B-2shows the location of the Flash module Flash UpgradeInstalling the Flash Module Page Numerics IndexIndex-2