Enterasys Networks 2H252-25R manual Fdx

Using LANVIEW

Table 4-1 LANVIEW LEDs (Continued)

LED Color State Recommended Action

TX	Off	Port enabled, and no
(Transmit)		activity.
		Should flash green every
		two seconds indicating
		BPDUs being sent if STA is
		enabled and there is a valid
		link.

1.Ensure that the STA is enabled and that there is a valid link.

2.Contact Enterasys Networks for assistance.

Green	Flashing. Indicates activity.	None.
	Rate indicates data rate.
Amber	Blinking. Port in standby.	1. Ensure that the port is not
	Port may be disabled due to	disabled.
		2. Contact Enterasys Networks for
	Spanning Tree.
		assistance.
Red	Flashing. Indicates collision	None, unless there is a large
	rate.	amount of activity. In this case,
		check for network configuration
		problems or a defective device.
	Solid. Diagnostic failure.	Contact Enterasys Networks for
		assistance.

The following port DPX and SPD LED indications are only valid when the LED MODE switch is in the DPX-SPD position.

FDX	Amber	Port is operating in standard	None.
(Full		mode (10 Mbps or
		100 Mbps).
Duplex
Status)	Green	Port is operating in full	None.
		duplex mode (20 Mbps or
		200 Mbps).
SPD (Speed	Amber	There is a link and the port	None.
Status)		is operating at 10 Mbps.
	Green	There is a link and the port	None.
		is operating at 100 Mbps.

Troubleshooting 4-5