Enterasys Networks manual Rack Mounting the 2H252-25R, Strain-Relief Bracket Screws

Installing the Device

Figure 3-2 Attaching the Strain-Relief Bracket

Strain-Relief

Bracket Screws

Strain-Relief

Bracket

														COM	25R-2H252
													CPU
													PWR
														SPD-DPX
24X 22X		20X	18X	16X	14X	12X	10X	8X	6X	4X	2X			TX-RX
23	21	19	17	15	13	11	9	7		5	3	1		MODE
														LED
24	22	20	18	16	14	12	10	8		6	4	2	SWITCH WORKGROUP ETHERNET FAST

4005_00_03

Rack Mounting the 2H252-25R

Proceed as follows to install the 2H252-25R into a 19-inch rack:

1.There are several mounting holes in the rackmount brackets and the bottom of the chassis so that each mounting bracket may be adjusted forward or backward to mount the device further into, or out of the rack, depending on the installation requirements. Position the rackmount brackets over the appropriate holes.

CAUTION: Do not attempt to attach the rackmount brackets with screws other than the 6-32 x 1/4-inch flathead screws shipped with the 2H252-25R. Use of longer screws may damage the unit.

2.Locate the four 6-32 x 1/4-inch flathead screws in the rackmount kit. Use these screws to attach the rackmount brackets to the bottom of the 2H252-25R as shown in Figure 3-3.

3-6Installation