Modem Hangup
Command
Hangup string that will be sent to the modem.
Default: ATH
Answer
Expected answer from the modem on the sent command.
Default: OK
Timeout
Define the time in seconds between the sent command and the expected answer before the command have failed.
Allowed values: 0 to 9999
Default: 3
Retries
Define the number of retries in case if a failed command.
Allowed values: 0 to 9999
Default: 1
Modem Connect (Dial Out)
Command
Dial out string that will be sent to the modem.
Default: ATDS=0 (dials the stored number in location 0, stored with AT&Z command)
Answer
Expected answer from the modem on the sent command.
Default: CONNECT
Timeout
Define the time in seconds between the sent command and the expected answer before the command have failed.
Allowed values: 0 to 9999
Default: 60
Retries
Define the number of retries in case if a failed command.
Allowed values: 0 to 9999
Default: 1
Modem Connect (Dial In)
Command
Dial in string that will be sent from the modem on an incoming call.
Default: RING
PPP
6609-2221
Contents
Installation
Safety
Before installation, maintenance or modification work
Approvals
Declaration of conformity
Declaration of Conformity
Introduction
Specification
Transient Protection
Configuration
Indicators LED
Application
Mounting /Removal
Maintenance
Installation
Received Data
Connections
Out Transmitted Data
CH1 RS-232 Connections, DCE
CH2 RS-232 Connections, DCE
ED-20 working mode
LED Indicators From left to right
Power
Transmitted Data incoming serial data
DIP Swiches is not used in this product, leave as it is
Factory settings
DIP Switch Settings
System Requirements
Installation of ED-Tool for ED-20
MAC address
Minimum
About PPP
Application mode
Functional description
Network interfaces
Brouter function
Configuration mode
PPP connection
Firewall function
Typical configuration procedures
Configuration
Configuration by ED-Tool for ED-20
Program Start
Serial Interface Channel 1 specific commands
ED-Tool for ED-20 commands
General commands
Selects type of connection, Serial or over the Network
Modem Settings
Modem Hangup
Modem AT-Commands
16 17 18 Modem Init
Modem Connect Dial Out
Password Set the login password
Network Settings
Login
PPP Network Interface
Brouter Settings
Brouter Settings
Brouter Mode
Firewall Settings
Firewall Settings
Firewall Mode
IP Address
Allowed values LL, Pstn Default Pstn
Default 57 600 bit/s
Allowed values None, RTS/CTS Default RTS/CTS
Allowed values
Connect at PWR on
Allowed values NO,YES Default no
Dial IN/OUT
DCD Control
Allowed values, 0, 1 to Default 0 function disabled
Default +++
Default 2 seconds
Default AT&F&D0S0=0&K3+MS=V34&W
Default Ring
Default ATH
Default Connect
Allowed values NONE, PAP, Chap Default None
Default ATA
Allowed values Default
Username
Remote address
0.0126.0.0.0 128.1.0.0 192.0.1.0 Default
Local IP
Subnet Mask
Brouter Settings IP Address
Refer to .2.2 General Modem settings and Dial IN/OUT
Default Off
Firewall Settings IP Address
Remote connection LAN Dial
Example of application with IP address settings
Application examples
LAN LAN Leased Line
LAN LAN PSTN, Brouter, Firewall
T03-03766609-222103.06 Mälartryck AB, Eskilstuna, Sweden