Edimax Technology ES-5226RS manual LED Indicators, Gigabit port LED Indicator

Page 11

LED Indicators

The LED Indicators display real-time information of systematic operation status. The following table provides descriptions of LED status and their meaning.


		LED		Status		Description

				Green		Power On
		Power
				Off		Power is not connected

				Green		The port works in 10/100 Full-duplex mode

				Blinks		Networking is active
				(continuously)		Networking is active
				(continuously)

		Act/Duplex		Blinks
		Act/Duplex		(off for about 2
				(off for about 2		The port works in 10/100 Half-duplex mode
				seconds and on		The port works in 10/100 Half-duplex mode
				seconds and on
				alternatively)

				Off		No device attached

				Amber		The port works at speed of 100Mbps
		Speed
				Blinks		The port works at speed of 10Mbps

The Description of LED Indicators

Gigabit port LED Indicator

The following table provides descriptions of Gigabit ports’ LEDs status and their

5

Image 11

Contents Page Firmware Version FCC Warning Content Page Troubleshooting Introduction FeaturesPackage Contents Page Front Panel Physical DimensionsHardware Description Page Gigabit port LED Indicator LED IndicatorsRear Panel Attaching Rubber Pads Desktop InstallationRack-mounted Installation Power On Small Workgroup Network ApplicationSegment Uplink About Web-based Management Web-Based ManagementMain User LoginAuthentication Configuration AdministratorSystem IP Configuration System Status Default Switch Setting and Reboot Port Management Port ConfigurationPort Configuration interface Port Mirroring Bandwidth Control Page Broadcast Storm Control Vlan Member Setting Port Based Vlan SettingVlan Member Setting Port Based interface Vlan Mode Page Vlan Pvid Index Setting Vlan Pvid Index Setting interface Per Port Counter Per Port Counter interface QoS Setting Priority Mode Class of Service Configuration Class of Service Configuration interface Security Filter MAC Address Filter interface Trunk Trunk ConfigurationTrunk Configuration interface Aggregation Information Configuration Backup/Recovery Firmware Update Updating Firmware to the flash interface Name of the firmware and press enter to update Reboot Logout „ Non-standard cables Troubleshooting„ Faulty or loose cables Incorrect connections„ Cabling Diagnosing LED Indicators„ Improper Network Topologies Standard Technical SpecificationEMI 10 /100BASE-TX Pin outs 10/100Base-TX Cable SchematicAppendix 10/100/1000Base-TX Pin outs 10/100/1000Base-TX Cable Schematic