Edimax Technology ES-5226RS manual FCC Warning

Page 3

FCC Warning

This Equipment has been tested and found to comply with the limits for a Class-A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. It may cause harmful interference to radio communications if the equipment is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

„Reorient or relocate the receiving antenna.

„Increase the separation between the equipment and receiver.

„Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

„Consult the dealer or an experienced radio/TV technician for help.

CE Mark Warning

This is a Class-A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Image 3
Contents Page Firmware Version FCC Warning Content Page Troubleshooting Features Package ContentsIntroduction Page Physical Dimensions Hardware DescriptionFront Panel Page Gigabit port LED Indicator LED IndicatorsRear Panel Desktop Installation Rack-mounted InstallationAttaching Rubber Pads Power On Small Workgroup Network ApplicationSegment Uplink About Web-based Management Web-Based ManagementMain User LoginAuthentication Configuration AdministratorSystem IP Configuration System Status Default Switch Setting and Reboot Port Management Port ConfigurationPort Configuration interface Port Mirroring Bandwidth Control Page Broadcast Storm Control Vlan Member Setting Port Based Vlan SettingVlan Member Setting Port Based interface Vlan Mode Page Vlan Pvid Index Setting Vlan Pvid Index Setting interface Per Port Counter Per Port Counter interface QoS Setting Priority Mode Class of Service Configuration Class of Service Configuration interface Security Filter MAC Address Filter interface Trunk Trunk ConfigurationTrunk Configuration interface Aggregation Information Configuration Backup/Recovery Firmware Update Updating Firmware to the flash interface Name of the firmware and press enter to update Reboot Logout „ Non-standard cables Troubleshooting„ Faulty or loose cables Incorrect connectionsDiagnosing LED Indicators „ Improper Network Topologies„ Cabling Standard Technical SpecificationEMI 10/100Base-TX Cable Schematic Appendix10 /100BASE-TX Pin outs 10/100/1000Base-TX Pin outs 10/100/1000Base-TX Cable Schematic