Edimax Technology ES-5226RS manual Name of the firmware and press enter to update

Page 49

name of the firmware) and press enter to update.

Command Prompt Window

Note The system will erase the flash at first and then update the new firmware during the update process. If the update process is not finished, the web page of Firmware Update will always be displayed when the switch powers on.

43

Image 49

Contents Page Firmware Version FCC Warning Content Page Troubleshooting Package Contents FeaturesIntroduction Page Hardware Description Physical DimensionsFront Panel Page Gigabit port LED Indicator LED IndicatorsRear Panel Rack-mounted Installation Desktop InstallationAttaching Rubber Pads Power On Small Workgroup Network ApplicationSegment Uplink About Web-based Management Web-Based ManagementMain User LoginAuthentication Configuration AdministratorSystem IP Configuration System Status Default Switch Setting and Reboot Port Management Port ConfigurationPort Configuration interface Port Mirroring Bandwidth Control Page Broadcast Storm Control Vlan Member Setting Port Based Vlan SettingVlan Member Setting Port Based interface Vlan Mode Page Vlan Pvid Index Setting Vlan Pvid Index Setting interface Per Port Counter Per Port Counter interface QoS Setting Priority Mode Class of Service Configuration Class of Service Configuration interface Security Filter MAC Address Filter interface Trunk Trunk ConfigurationTrunk Configuration interface Aggregation Information Configuration Backup/Recovery Firmware Update Updating Firmware to the flash interface Name of the firmware and press enter to update Reboot Logout „ Faulty or loose cables TroubleshootingIncorrect connections „ Non-standard cables„ Improper Network Topologies Diagnosing LED Indicators„ Cabling Standard Technical SpecificationEMI Appendix 10/100Base-TX Cable Schematic10 /100BASE-TX Pin outs 10/100/1000Base-TX Pin outs 10/100/1000Base-TX Cable Schematic