Edimax Technology ES-5226RS manual

Page 27

„Tx Rate: Pull down the selection menu to choose the transmitting rate. When Speed Base is set as Low, the transmitting rate for all the ports is in the range between 32K bytes and 8M bytes. When Speed Base is set as High, the transmitting rate for port 1 ~ 24 is in the range between 256K bytes and 64M bytes; the transmitting rate for port 25 & 26 is in the range between 2M bytes and 510M bytes.

„Rx Rate: Pull down the selection menu to choose the receiving rate. When Speed Base is set as Low, the receiving rate for all the ports is in the range between 32K bytes and 8M bytes. When Speed Base is set as High, the transmitting rate for port 1 ~ 24 Is in the range between 256K bytes and 64N bytes; the receiving rate for port 25 & 26 is in the range between 2M bytes and 765M bytes.

„And then, click

Update to make the settings taken effect.

21

Image 27
Contents Page Firmware Version FCC Warning Content Page Troubleshooting Features Package ContentsIntroduction Page Physical Dimensions Hardware DescriptionFront Panel Page Gigabit port LED Indicator LED IndicatorsRear Panel Desktop Installation Rack-mounted InstallationAttaching Rubber Pads Power On Small Workgroup Network ApplicationSegment Uplink About Web-based Management Web-Based ManagementMain User LoginAuthentication Configuration AdministratorSystem IP Configuration System Status Default Switch Setting and Reboot Port Management Port ConfigurationPort Configuration interface Port Mirroring Bandwidth Control Page Broadcast Storm Control Vlan Member Setting Port Based Vlan SettingVlan Member Setting Port Based interface Vlan Mode Page Vlan Pvid Index Setting Vlan Pvid Index Setting interface Per Port Counter Per Port Counter interface QoS Setting Priority Mode Class of Service Configuration Class of Service Configuration interface Security Filter MAC Address Filter interface Trunk Trunk ConfigurationTrunk Configuration interface Aggregation Information Configuration Backup/Recovery Firmware Update Updating Firmware to the flash interface Name of the firmware and press enter to update Reboot Logout „ Non-standard cables Troubleshooting„ Faulty or loose cables Incorrect connectionsDiagnosing LED Indicators „ Improper Network Topologies„ Cabling Standard Technical SpecificationEMI 10/100Base-TX Cable Schematic Appendix10 /100BASE-TX Pin outs 10/100/1000Base-TX Pin outs 10/100/1000Base-TX Cable Schematic