Edimax Technology ES-5226RS manual Rear Panel

Page 12

meaning.


		LED		Status		Description

				Green		The port works in 10/100 Full-duplex or
				Green		gigabit mode
						gigabit mode

				Blinks		Networking is active
				(continuously)		Networking is active
				(continuously)

		Act/Duplex		Blinks
		Act/Duplex		(off for about 2
				(off for about 2		The port works in 10/100 Half-duplex mode
				seconds and on		The port works in 10/100 Half-duplex mode
				alternatively)

				Off		No device attached

				Green		The port works at speed of 1000Mbps
		Speed
				Blinks		The port works at speed of 100Mbps

The Descriptions of Gigabit port LED Indicators

Rear Panel

The 3-pronged power plug is located at the rear panel of the ES-5226RS shown below. The switch will work with AC in the voltage range between 100 and 240V and Frequency of 50-60Hz.

The Rear Panel of ES-5226RS

6

Image 12

Contents Page Firmware Version FCC Warning Content Page Troubleshooting Features Package ContentsIntroduction Page Physical Dimensions Hardware DescriptionFront Panel Page LED Indicators Gigabit port LED IndicatorRear Panel Desktop Installation Rack-mounted InstallationAttaching Rubber Pads Power On Network Application Small WorkgroupSegment Uplink Web-Based Management About Web-based ManagementUser Login MainAdministrator Authentication ConfigurationSystem IP Configuration System Status Default Switch Setting and Reboot Port Configuration Port ManagementPort Configuration interface Port Mirroring Bandwidth Control Page Broadcast Storm Control Vlan Setting Vlan Member Setting Port BasedVlan Member Setting Port Based interface Vlan Mode Page Vlan Pvid Index Setting Vlan Pvid Index Setting interface Per Port Counter Per Port Counter interface QoS Setting Priority Mode Class of Service Configuration Class of Service Configuration interface Security Filter MAC Address Filter interface Trunk Configuration TrunkTrunk Configuration interface Aggregation Information Configuration Backup/Recovery Firmware Update Updating Firmware to the flash interface Name of the firmware and press enter to update Reboot Logout Troubleshooting „ Faulty or loose cablesIncorrect connections „ Non-standard cablesDiagnosing LED Indicators „ Improper Network Topologies„ Cabling Technical Specification StandardEMI 10/100Base-TX Cable Schematic Appendix10 /100BASE-TX Pin outs 10/100/1000Base-TX Pin outs 10/100/1000Base-TX Cable Schematic