Lyngdorf Audio owner manual Integrated amp / Preamp-poweramp RP-1

3.If your integrated amplifier or preamp has a ‘tape 2’ loop (sometimes called recording loop) or ‘Pre in/out’:

•Connect the output of the ‘tape 2’ loop / ‘Pre out’ to the input of the RP-1.

•Then connect the output of the RP-1 to the input of the ‘tape 2’ loop / ‘Pre in’.

Using this configuration enables you to use multiple audio sources without switching source and/or cables, since the ‘tape 2’ loop ‘Pre in/out’ is always active and not depending on other used inputs and outputs.

Source(s)

DPA-1Digital Pre-Amplifier

Integrated amp / Preamp-poweramp

RP-1

When using Option 2 or a ‘tape 2’ loop as described in Option 3, be aware that your amplifiers volume control is set at an appropriate level when making the RoomPer- fect calibration.

Please refer to the chapter “Setting the Measurement Volume Level” for further information.

13