Lyngdorf Audio Comprehensive Guide to Setting Up Your RP-1 Speaker System

Setup options of Main and Line outputs

As described in “Routing” and “Crossover Frequency” there are many ways to utilize the Main and Line out- puts. Here we have described the three most common set-up´s. Please note the products, outputs and cross- over frequencies are chosen randomly in these descriptions. Combine them as you see fit.

1.Single-amp set-up with full range main speakers (no subwoofer).

A poweramp is connected to Main Outputs Left and Right. No crossover is selected.

Main Output Left

No filter

Speaker

RP-1Main Output Right

No filter

Poweramp Speaker

2.Poweramplifier and subwoofer set-up.

A poweramp is connected to the Main Outputs Left and Right and the highpass crossover is set at 80Hz. The Subwoofer is connected to the Line Output and the lowpass crossover is set at 80Hz. Remember to bypass or set the subwoofer cut-off frequency to maximum.

Main Output Left + Right

Highpass filter set at 80Hz

Speakers Poweramp

RP-1Line Output Right

Mono lowpass filter set at 80Hz

Active subwoofer

3.Lyngdorf 2+2 setup.

A poweramp is connected to Line Outputs Left and Right and the highpass crossover is set at 400Hz. Lyngdorf boundary woofers are connected to Main Outputs Left and Right, through a poweramp, and the lowpass crossover set at 400Hz.

Line Output Left + Right RP-1Highpass filter set at 400Hz

Main Output Left + Right Lowpass filter set at 400Hz

Speakers Poweramp Poweramp Boundary woofers

14