Lyngdorf Audio owner manual Connecting the RP-1, Connecting to sources and ampliﬁers

Page 12

Connecting the RP-1

The photos used are only meant as visual aids to show the versatility of the RP-1, Lyngdorf Audio doesn’t necessarily carry all other products with the described speci- ﬁcations in the product assortment.

Connecting to sources and ampliﬁers

The RP-1 is very simple to hook up. There are three basic ways to connect the RP-1 to your system.

1.Connect all sources to your preampliﬁer and connect it to the RP-1 input. Then connect the RP-1 output signal to a powerampliﬁer.

Source(s)

DPA-1Digital Pre-Amplifier

Preamp

RP-1

Poweramp

2.Connect a single audio source to the RP-1 input.

Then connect the RP-1 output signal to your integrated- or preampliﬁer.

Source

RP-1

DPA-1Digital Pre-Amplifier

Integrated amplifier / Preamp

12

Image 12

Contents RP-1 RoomPerfect Page Table of Contents Operating Voltage Unpacking the RP-1Serial Number Registration Introduction Accessories Remote controlFront Panel ControlsDisplay Indicators Rear PanelPage Remote Control Page Connecting the RP-1 Connecting to sources and ampliﬁersIntegrated amp / Preamp-poweramp RP-1 Setup options of Main and Line outputs Menu System Navigating the Menu SystemMenu Tree Introduction to RoomPerfect Global ListeningFocus Listening VoicingGuided Setup RoomPerfectSetting the Measurement Volume Level Focus Measurement Room MeasurementsAdding more Room Measurements Calculation of Focus and Global Filters Advanced Options Change Focus PositionMeasure Room Pos RoomKnowledge RoomCorrectionDisplay Timeout DisplayInput Connection Display BrightnessAdvanced Setup Input SensitivityCommunication Comm AddressLine Out Level RoutingCrossover Frequency Filter TypeDelay Remote ControlFactory Reset Firmware VersionsTroubleshooting RoomPerfectRP-1 Firmware Upgrading Connectors Cleaning and MaintenanceMains Connector Balanced InputsTechnical Speciﬁcations AudioProtection MainsTechnical Assistance Appendix Voicing CurvesPage