Lyngdorf Audio RP-1 owner manual Troubleshooting, RoomPerfect

Troubleshooting

RoomPerfect™

No microphone connected

The error message ‘No microphone connected’ is displayed when no microphone is connected to the RP-1.

Solution:

• Connect the microphone on the back panel.

No signal

1.The error message ‘Fault – No signal’ is displayed when the incoming signal is classified as pure noise. This happens when the RP-1´s measuring signal is too low compared with the noise from the local environment.

2.The volume setting of your amplifier and/or RP-1 measuring volume is to low.

3.The above error message is also displayed when the loudspeakers are not connected.

Solution:

•Reduce the noise in your measuring environment.

•Raise the volume setting of your amplifier and/or RP-1 measuring volume before continuing with the measurement.

•Connect your loudspeakers.

Low signal

The error message ‘Fault – Low signal’ is displayed when the measurement has taken more than 5 minutes for the low frequency signal or 2 minutes for the high frequency signal. This happens when the system calibration volume is low compared to the background noise of your environment, some- thing that results in prolonged measuring times.

Solution:

•Raise the RP-1´s measuring volume or the volume setting of your amplifier before continuing with the measurement, or reduce the noisy elements in your environment.

Signal clipping

1.The error message ‘Fault – Signal clipping’ is displayed when the incoming signal is classified as too loud resulting in clipping (distortion).

2.A loud noise from the local environment that has corrupted the measurement results in this error message.

Solution:

•Lower the measuring signal volume before continuing with the measurement.

•Repeat the measurement with no changes; however refrain from making excessive noise when measuring.

31