Advanced Options, Change Focus Position

Advanced Options

This section describes the options in the advanced menu, which is available after Guided Setup has been completed. Here you can change the listening position and add more room measurements, check the RoomKnowledge of your current set-up, and check the RoomCorrection for the different ﬁlters.

Advanced options

Change Focus Pos

Measure Room Pos

RoomKnowledge

RoomCorrection

If the RP-1 is connected before the volume control of your ampliﬁer e.g. when using Option 2 or a ‘tape 2’ loop as described in Option 3 in the “Connecting the RP-1” chapter, be aware that the volume control of your ampliﬁer is set at the same level as when making the initial RoomPerfect calibration.

If you do not remember this setting, you will need to perform a new guided setup.

Change Focus Position.

If you want to replace your current listening position (Focus ﬁlter), place the microphone correctly in the new listening position and the measurement process can commence as described in the ‘Guided Setup’ chapter.

After a successful measurement the message ‘RoomKnowledge XX% - Measurement ok’ is displayed. Press Enter to continue.

The message ‘Replace old focus measurement?’ will appear.

•choose Yes to replace the measurement or,

•choose No to exit without saving the current measurement.

Measure Room Pos.

It is always possible to add more room measurements, which can increase RoomKnowledge and there- by ﬁne tune both room correction ﬁlters (Focus and Global).

Press Enter to start a new room measurement.

First the volume must be calibrated, as described in the ‘Guided Setup’ chapter. Then place the micro- phone in a random room position and the measurement can commence.

The volume can be changed at any time between measurements to suit a particular measurement situ- ation.

After a successful room measurement the RoomKnowledge is re-calculated and displayed as ‘Room- Knowledge XX% - Measurement X ok’. Press Enter to continue.