Lyngdorf Audio RP-1 owner manual Technical Specifications, Audio, Protection, Mains, Mechanical

Technical Specifications

Audio

Parameter	Value	Note
Balanced input connectors	3 pin XLR, gold-plated.	Case=Gnd, Pin1=Gnd,
		Pin2=Hot(+), Pin3=Cold(-)
Balanced input impedance	10KOhm	AC-coupled.
Unbalanced input connectors	RCA (phono) jack, gold-plated.	Case=Gnd, Tip=Hot(+)
Unbalanced input impedance	10KOhm	AC-coupled
Input sensitivity	4.4V (2.2V with high sens.)
DAC Out impedance	50Ohm
Unbalanced output	Unity	0dB according to input level
Balanced output	Unity	0dB according to input level
Frequency Response 20 - 20KHz	+/-0.1dB	RoomPerfect Highpass Filter
		-3dB at 18Hz
THD+N A-wgt	-103dB	Neutral voicing - ref 4.4V
Analog to Analog
S/N Ratio	113dB	Neutral voicing - ref 4.4V
Analog to Analog
Dynamic Range	113dB	Neutral voicing - ref 4.4V
Analog to Analog
Channel Separation	114dB	AC Sweep from 125 - 16KHz

All audio measurements, except frequency response, are measured with a 20KHz low-pass filter in ac- cordance with AES-17.

Protection

Parameter	Value	Value
Grounding	Mains earth, chassis and audio
	ground are connected internally.
Over temperature	Mains-transformer.	Auto resetting thermal fuse in
		mains transformer.

Mains

Parameter	Value	Note
Mains input connector	IEC 320 cold type	Mains lead supplied.
Mains voltage range	100-240V AC, 50–60Hz
Power consumption	4 W	STANDBY mode. 230V AC.
Power consumption	23 W	OPERATE mode. 230V AC.

Mechanical

Parameter	Value	Note
Width	450mm (17.72”)
Depth	355mm (13.98”)
Height	100mm (3.94”)	Including feet.
Net weight	6.6 Kg (14.6 lb.)
Shipping weight	9.9 Kg (21.8 lb.)	2 shipping boxes

35