Dell 7000 Series manual Stacking CLI Commands, Small Configuration

Page 33

Stacking Dell PowerConnect 7000 Series Switches

Small Configuration

•6 switches stacked

•4 VLANs, all ports are members of all VLANs

•2/2 static/dynamic lags with 8 members each

•1 MSTP instance with VLANs

•15 ACLs applied on 15 interfaces

•5 Diffserv service interfaces with policies on 5 interfaces

•2 VLAN routing interfaces

•16 L2 Multicast group entries

•256 ARP entries

•16 Unicast routes

Parameter	Timing
L2 loss duration (non-failed or rerouted stack member)	0 msec
L2 loss duration (failed/rerouted stack member)	10 msec
L3 loss duration (failed/rerouted stack member)	12 msec
IPMC loss duration (failed/rerouted stack member)	12 msec
L2 convergence time	14.770 sec
L3 convergence time	14.800 sec
IPMC convergence time	17.540 sec
Total convergence time	17.540 sec

Stacking CLI Commands

The following stacking commands are available from the CLI. See the CLI Reference Guide for more detailed information about the commands.

boot auto-copy-sw	show stack-standby
clear checkpoint statistics	show switch stack-ports
initiate failover	show switch stack-ports counters
member	show switch stack-ports diag
movemanagement	show supported switchtype
nsf	show switch
set description	stack-port
show checkpoint statistics	switch renumber
show nsf

Page 31

Image 33

Contents Dell Technical White Paper Stacking Dell PowerConnect Series SwitchesStacking Dell PowerConnect 7000 Series Switches Contents Introduction ApplicabilityStacking and Management Stacking and Redundancy Stacking and PerformanceDual Stacking Modules Configured in a Ring Power-Up Sequencing Considerations Mixing M6348 and PC7000 Series Switches in a StackConsole#boot auto-copy-sw allow-downgrade Initial Installation and Power-up of a Stack Selecting the Standby Unit Selecting the Master UnitUpdating the Firmware on a Stack Automatic UpdateManual Update FTP Creating a Separate Vlan for File DownloadsFrom the Switching Vlan Vlan Membership page, click Add Navigate to the Routing IP IP Interface Configuration Page Stacking Dell PowerConnect 7000 Series Switches Click Apply Adding a Stack Member with Minimal Interruption Removing a Stack Member with Minimal Interruption Merging Two Operational Stacks Master FailoverEffect of Master Failover on PoE Devices Stack Member Failover Failover ScenariosScenario Stack Split Stack Split with Manager Failure Nonstop Forwarding Nonstop Forwarding Scenario Initiating a Warm Failover of the Manager UnitNonstop Forwarding Example Router NSF Scenario Configuration via CLIStack Switch Switch NSF Example Parameter Timing NSF Re-convergence TimingSmall Configuration Stacking CLI CommandsSummary Stacking Web Interface