Carrier Access 3104s quick start Configure Serial1 as WAN, Set Network to WAN

Page 29

Quick Start

Basic Configuration

Configure Serial1 as WAN

In the web-browser:

1.Select Network Connections from the Navigation bar.

2.Select Serial1.

3.Select Settings button.

4.Set Network to WAN.

5.Select Apply to apply the new settings.

Adit 3104 - Release 1.6

29

Image 29

Contents Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD PrecautionsInstallation Environment Installation User SafetyFerrite bead shipped with Adit chassis Compliant InstallationFerrite Beads Wall Mounting To rack mount the Adit 3000, follow the instructions below Rack Mounting Optional FeatureTray Slide Adit 3104, 3200 and 3400 Battery Backup Back Chassis OverviewFront Front of Adit Interface ConnectorsBack of Adit Grounding the UnitBattery Connection PowerTo connect AC power To connect -48 VDC powerPair Pin Function Color Code Pair Telco ConnectorDirection RS-232 Craft Port Female DB-9Description DS1/E1 RJ-48C DS1/E1 Connection PortsPin Name Description State DescriptionEthernet RJ-45 Reset Button10/100Base-TX Ethernet Alarm/Status LEDs Command Description To access the management consoleWeb-Based Management #show interface ethernet 2 Eth WANSet the New-line/Transmit value CR+LF Setting up a CLI ConnectionLog Adit 3104 show version Key Enabled Software FeaturesSetup Adit for access via Web-Browser Basic ConfigurationSelect Restore Defaults Restore Factory DefaultsModify Default Admin User Quick Start Web-browser Configure Ethernet WAN InterfaceSelect Apply to apply the new settings Set Network to WAN Configure Serial1 as WANSelect the Enable button Select Use SIP Proxy Configure the Adit 3104 as a SIP Line GatewayQuick Start Quick Start Basic Configuration Adit 3104 Release