Carrier Access 3104s quick start Tray Slide

Page 9

Quick Start

Installation

3. Place the Adit 3000 on the Tray Slide and attach with the 4 screws removed in step 2. screws

screws

Tray Slide

4. Slide the assembled piece (Adit 3000 and Tray Slide) onto the installed Rack Mounting Tray.

5. Secure the Tray Slide to the Rack Mounting Tray with the attached screws on the Tray Slide.

NOTE: the mounting brackets are designed to not allow units to be mounted closer than recommended.

Adit 3104 - Release 1.6

9

Image 9

Contents Adit Page Quick Start Guide Electrostatic Discharge ESD Precautions Installation EnvironmentUnpacking and Inspection Installation User SafetyCompliant Installation Ferrite BeadsFerrite bead shipped with Adit chassis Wall Mounting To rack mount the Adit 3000, follow the instructions below Rack Mounting Optional FeatureTray Slide Adit 3104, 3200 and 3400 Battery Backup Chassis Overview FrontBack Front of Adit Interface ConnectorsBack of Adit Grounding the UnitBattery Connection PowerTo connect AC power To connect -48 VDC powerPair Pin Function Color Code Pair Telco ConnectorRS-232 Craft Port Female DB-9 DescriptionDirection DS1/E1 RJ-48C DS1/E1 Connection PortsPin Name Description State DescriptionReset Button 10/100Base-TX EthernetEthernet RJ-45 Alarm/Status LEDs Command Description To access the management consoleWeb-Based Management #show interface ethernet 2 Eth WANSet the New-line/Transmit value CR+LF Setting up a CLI ConnectionLog Adit 3104 show version Key Enabled Software FeaturesSetup Adit for access via Web-Browser Basic ConfigurationSelect Restore Defaults Restore Factory DefaultsModify Default Admin User Quick Start Web-browser Configure Ethernet WAN InterfaceSelect Apply to apply the new settings Set Network to WAN Configure Serial1 as WANSelect the Enable button Select Use SIP Proxy Configure the Adit 3104 as a SIP Line GatewayQuick Start Quick Start Basic Configuration Adit 3104 Release