Setting up a CLI Connection

Quick Start

A CLI connection will require the LAN or WAN IP address of the unit. Note: If the WAN IP address is used, the remote admin WAN access must be enabled with the following command sequence:

Command	Description
Username: admin	Log into the system (username and password).
Password: ********
Adit 3104> enable	Enter the Privileged mode.
Password: ********	Enter password for the Privileged mode.
#configure terminal	Enter the Configuration mode.
(config)# remote-admin web	Enable remote web admin.
primary-port enable

NOTE: For Adit 3104 CLI commands see the Adit 3000 CLI Reference Manual. This is a separate document and can be found on the CD that is provided with the product, or on the Carrier Access customer website.

To connect with CLI, set up the connection:

zIf connecting via the Ethernet 100Base-TX connection, use a Telnet TCP/IP program to access the CLI. This requires an IP address of the unit.

Note: to display the current IP address of the unit, use the ifconfig command.

zIf connecting via RS-232, the port settings should be set to:

Bits per second: 115200	Data bits: 8
Parity: None	Stop bits: 1
Flow control: None

zSet your Terminal Emulation to: VT100

NOTE: When using Tera Term (Telnet program) TCP/IP, CLI commands will not be recognized until the following setup is completed.

zIn Tera Term go to Setup/Terminal

zSet the New-line/Transmit value CR+LF

20	Adit 3104 - Release 1.6

Command

Description

zSet the New-line/Transmit value CR+LF