freeView IP 800 User’s Manual
Using a 10 Mbps Connection
For 10BASE-T Ethernet networks, the Ethernet adapter uses Category 3, 4, 5 or 6 UTP cable. To establish a 10 Mbps connection, the cable must be connected to a 10BASE-T hub.
•Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.
•Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the adapter’s connector.
Using a 100 Mbps Connection
For 100BASE-TX Fast Ethernet networks, the freeView IP 800 supports Category 5 or higher UTP cabling. To establish a 100 Mbps connection, the cable must be connected to a 100BASE-TX hub or switch.
•Make sure that the cable is wired appropriately for a standard 100BASE-TX adapter.
•Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the adapter’s connector.