Zonet Technology ZEW3003 manual Advanced

Page 26

4.10 Advanced

￿Frag Threshold: Specify the maximum size of packet during the fragmentation of data to be transmitted. Default value is 2346.

￿RTS Threshold: When the packet size is smaller the RTS threshold, ZEW3003 will not use the RTS/CTS mechanism to send this packet. Default value is 2347.

￿Beacon Interval: The interval of time ZEW3003 broadcast a beacon. Beacon is used to synchronize the wireless network. Default value is 100.

￿Transmit Rate: For different requirement, you can select one of the suitable Basic Data Rates. Default value is Auto.

￿Preamble Type

￿Long can provide better wireless LAN compatibility.

￿Short can provide better wireless LAN performance.

￿802.11g Protection: It also called CTS Protection. It is recommended to Enable the protection mechanism. This mechanism can decrease the rate of data collision between 802.11b and 802.11g wireless stations. When the protection mode is enabled, the throughput of ZEW3003 will be a little lower due to many of frame traffic should be transmitted

￿Wireless VLAN: Default value is Disabled.

24

Image 26
Contents Page Copyright Statement Table of Contents Introduction FeaturesPackage Contents WelcomeHardware Installation Panel Layout Front PanelSystem Requirements Installation Environment RequirementsRear Panel Hardware Connection Configure your computer TCP/IP Address SettingSelect Internet Protocol TCP/IP and click Properties Configure your ZEW3003 LogStatus Status StatisticsLAN Setup 4.3.1 LAN Setup Dhcp InfoRadio 1 AP Client 3 WDS 4 AP+WDS Repeater 2 WEP SecurityNone 3 802.1X Enterprise WPA Personal WPA Enterprise6 WPA2 Personal 7 WPA2 Enterprise8 WPA&WPA2 Personal 9 WPA&WPA2 EnterpriseWDS MAC FilterSite Survey Client InfoAdvanced Misc Troubleshooting