2.1.2 Rear Panel
The rear panel contains the following features. (Viewed from left to right)
| Name | Description |
| Power Connector | Power Jack only use the power adapter applied with |
| ZEW3003 to prevent damage | |
|
| |
| One LAN 10/100Mbps RJ45 port for connecting to the | |
| router/modem, local PC or switch/hub. | |
|
| |
| Reset Button | Factory Default Reset button |
| Antenna Connector | One external dipole antenna |
There is a way to reset the ZEW3003’s factory defaults by using the Factory Default Reset button:
1.Turn off ZEW3003’s power
2.Press and hold the default reset button and turn on ZEW3003 at the same time.
3.Hold the button until the system LED lights up (about 10 seconds)
4.Release the reset button and wait for ZEW3003 to reboot.
Note: Ensure ZEW3003 is powered on before it restarts completely.
2.2 System Requirements
Computer or network devices with wired or wireless network interface card
TCP/IP protocol must be installed on each PC
Web browser Microsoft Internet Explorer 6.0 or later
An available power socket
2.3 Installation Environment Requirements
Do not in direct sunlight or near a heater or heating vent
Do not in cluttered or crowded place. There should be at least 2 inches (5 cm) of clear space on all sides of ZEW3003
Well ventilated (especially if it is in a closet)
Operating temperature: 0°C~40°C
Operating Humidity: 10%~90%RH,
4