Zonet Technology ZEW3003 manual Hardware Connection

Page 7

2.4 Hardware Connection

Note: Before connecting ZEW3003, be sure to power off your computer, DSL/Cable modem, and ZEW3003. To achieve maximum wireless coverage, tilt ZEW3003’s antenna outward at 45° angle.

1.Connect one end of the cable to your broadband router, PC or Switch/Hub port and connect the other end to the LAN port of ZEW3003.

2.Power on ZEW3003 by connecting one end of the supplied power adapter to the power jack of ZEW3003 and connecting the other end to an electrical outlet.

3.Power on your wireless device.

4.Make sure the LEDs of ZEW3003 are lit. If not, try the above steps again, or jump to “Troubleshooting” for possible reasons and solution

5

Image 7
Contents Page Copyright Statement Table of Contents Welcome FeaturesPackage Contents IntroductionPanel Layout Front Panel Hardware InstallationRear Panel Installation Environment RequirementsSystem Requirements Hardware Connection TCP/IP Address Setting Configure your computerSelect Internet Protocol TCP/IP and click Properties Log Configure your ZEW3003Status Statistics StatusDhcp Info LAN Setup 4.3.1 LAN SetupRadio 1 AP Client 3 WDS 4 AP+WDS Repeater None Security2 WEP 3 802.1X Enterprise WPA Enterprise WPA Personal7 WPA2 Enterprise 6 WPA2 Personal9 WPA&WPA2 Enterprise 8 WPA&WPA2 PersonalMAC Filter WDSClient Info Site SurveyAdvanced Misc Troubleshooting