Zhone Technologies, Inc. | IMACS Product Book, Version 4 |
|
|
The two transmission protocol supports switched connectivity to ISDN capable switches and D channel signaling on either a full DS0 or multiplexed 4:1 on a single DS0. The ability to multiplex 4 channels onto one DS0 allows for more efficient provisioning. The 826361 and 826461 cards only support 3 DS0s at this time.
Another application of the BRI card is for leased line, or IDSL (ISDN Digital Subscriber Loop) as shown in Figure
18.This allows for a DDS type circuit, with 2 * 64 kbps bearer channels over a single wire pair. The leased circuit can be any standard 2B1Q (U interface) NTU device that supports
The requirements are specified in
Leased Line or IDSL (2B1Q)
DTE 2B1Q
NTU
IMACS | IMACS |
| T1/E1 carrier |
| Network |
2B1Q DTE NTU
Figure 17 - IMACS BRI Card In A Leased Line or IDSL Application
N T 1
N T 1
|
|
| C e n t r a l O f f i c e | |
|
|
| T 1 | |
I M A C S | w i t h | D 4 C h a n n e l B a n k | ||
B R I T E | c a r d | |||
I S D N | ||||
|
|
| ||
|
|
| S w i t c h | |
|
|
| T 1 | |
I M A C S | w i t h |
| ||
B R I T E | c a r d |
|
Figure 18 - Use of Legacy D4 Equipment Application
BRI Card Models
In both cases, leased line and BRITE, B channels carrying voice traffic on the BRI card can be compressed through the ADPCM card to extend the user’s Servers. The only limitation on BRI traffic is that NTUs or NT1s must be located less than 18,000 feet from the system unit.
March 2001 | Page 58 |