Chapter 4 Functional Description
In this case, the MVME3100 supports:
Mezzanine Type: | PMC = PCI Mezzanine Card |
| |
Mezzanine Size: | Double width and standard depth |
| (150mm x 150mm) with front panel |
| |
PMC Connectors: | J11, J12, J13, J14, J21, J22, and J23 |
| (32/64-bit PCI with front and rear I/O) on J14 only |
| |
Signaling Voltage: | VIO = +3.3V (+5V tolerant) or +5V, selected by keying |
| pin |
| |
Note On PMC site 1, the user I/O – J14 signals will only support the low-current, high-speed signals and are not to be used for any current bearing power supply usage. The maximum current rating of each pin/signal is 100 mA.
USB
The USB 2.0 host controller provides USB ports with integrated transceivers for connectivity with any USB-compliant device or hub. USB channel 1 is routed to a single USB connector located at the front panel. DC power to the front panel USB port is supplied via a USB power switch, which provides soft-start, current limiting, over-current detection, and power enable for port 1. Refer to the µPD720101 USB 2.0 Host Controller Datasheet listed in Appendix B, Related Documentation, for additional details.
PMC Expansion
The MVM3E3100 provides additional PMC module capability through the use of a connector on bus C that is compatible with the PMCspan boards. Up to four additional PMC modules may be added by using existing PMCspan boards. Refer to the PMCspan PMC Adapter Carrier Board Installation and Use manual listed in Appendix B, Related Documentation, for additional details.
General-Purpose Timers
There are a total of eight independent, 32-bit timers. Four timers are integrated into the MPC8540 and four timers are in the PLD. The four MPC8540 timers are clocked by the RTC input, which is driven by a 1 MHz clock. The clock source for the four timers in the PLD is 25 MHz. Refer to the MPC8540 Reference Manual listed in Appendix B, Related Documentation, for additional details and/or programming information.
Real-time Clock Battery
There is an on-board Renata SMT battery holder on the MVME3100. This SMTU2430-1 holder allows for quick and easy replacement of a 3V button cell lithium battery (CR2430), which provides back-up power to the on-board DS1375 RTC. A battery switching circuit provides automatic switching between the 3.3V and battery voltages. The battery provides backup power to the RTC for a minimum of one year at nominal temperature.
44MVME3100 Installation and Use (V3100A/IH1)