Chapter 5 Pin Assignments
Table 5-13. MVME721 Host I/O Connector (J10) Pin Assignments
49 | No Connect | GND | 50 |
|
|
|
|
51 | No Connect | No Connect | 52 |
|
|
|
|
53 | +5V | No Connect | 54 |
|
|
|
|
55 | No Connect | No Connect | 56 |
|
|
|
|
57 | No Connect | +3.3V | 58 |
|
|
|
|
59 | No Connect | No Connect | 60 |
|
|
|
|
61 | No Connect | No Connect | 62 |
|
|
|
|
63 | No Connect | No Connect | 64 |
|
|
|
|
Planar sATA Power Connector (J30)
There is one 2mm pitch header installed as a planar header on the MVME3100 board to provide power to a serial ATA (sATA) drive mounted on the board or somewhere within the chassis. The pin assignments for this header are as follows:
Table 5-14. Planar sATA Power Connector (J30) Pin
Assignments
Pin
1
2
3
4
Signal
+5V
+5V
GND
GND
USB Connector (J27)
There is one USB Type A connector located on the MVME3100 front panel. The pin assignments are as follows:
Table 5-15. USB Connector (J27) Pin Assignments
Pin | Signal |
1 | USB_VBUS (+5.0V) |
|
|
2 | USB_DATA- |
|
|
3 | USB_DATA+ |
|
|
4 | GND |
|
|
62MVME3100 Installation and Use (V3100A/IH1)