Advantech ADAM-4550 user manual Antenna Installation

Page 13

2.8 Antenna Installation

Indoor communication distance is about 300 to 550 ft. using a standard 2 dB antenna. Howev- er, actual distance depends on environmental conditions as well as antenna type and position- ing.

Longer communication distances can be achieved by using an antenna with a higher gain. A table of communication ranges as a function of differing combinations of antennas (at the source and receiving ends) is displayed below.

Antenna

24 dB

18 dB

11 dB omni-

Gain at

directional

directional

directional

either end

 

 

 

 

 

 

 

24 dB

10 Km

5 Km

2 Km

directional

 

 

 

 

 

 

 

18 dB

5 Km

2.5 Km

1 Km

directional

 

 

 

 

 

 

 

11 dB omni-

2 Km

1 Km

0.5 Km

directional

 

 

 

 

 

 

 

Note : 1. While using directional antennas, care should be taken to install and adjust the anten- na‘s direction according to the instructions of the antenna’s manufacturer. Please see the example specification for an external 24 dBi an- tenna at appendix A.

2.A user’s license may be required to use a directional antenna. Please consult your local authority for local regulations.

3.We strongly recommend that you install ADAM-4550 as near as possible to its antenna. Where the antenna has to be located at a dis- tance from the ADAM, special RF cable is re- quired. Please see the example cable connec- tion arrangement in appendix B.

4.Omnidirectional antennas should be used when the ADAM-4550 communicates with more than one other ADAM-4550 unit located in dif- ferent directions.

ADAM-4550 User's Manual

13

Image 13
Contents ADAM-4550 Contents FCC Warning FCC IdentificationIntroduction FeaturesBuilt-in Intelligence Page Basic Configuration InstallationFactory Default Settings Power SupplySoftware Configuration RS-485 Communication WiringConfiguring ADAM-4550 Basic Connection Diagram Pin Assignment Uploading a New Version of Firmware Using the Diagnostics Functions Antenna Installation Using ADAM-4550 ADAM-4550-S RS-232 115.2ADAM-4550-01 Test Sample Syntax ADAM-4550 Command SetConfiguration Mode Commands Data Pass Mode Commands Set New Configuration Command DescriptionsExample Command Write Identification Read ConfigurationSet Delimiter Character Read IdentificationSet Data Gate Read Delimiter CharacterRemain at Open Gate/Write to Flash Response Read Data Gate Status DescriptionExample Read Firmware VersionUploading Read Module NameSend Data to Remote Data Pass mode Get Error Rate StatisticsDBi Omni-Directional Antenna Appendix a External Antenna OptionsDBi Grid Parabolic Reflector Directional Antenna Appendix B External Antenna Wiring Diagram