4.13. Get Error Rate Statistics
Description Requests to get the current RF error rate statistics from the module at address AA.
This command only works in
Data Pass mode.
Syntax &AAQ(cr)
Response !AAQ(statistic data)(cr) if the command is valid
?AA(cr) if an invalid command is entered
The statistic data format is in the following order:
Total number of packets: 4 bytes
Total number of CRC error pack- ets received: 2 bytes
Total number of checksum error packets received : 2 bytes
Total number of good packets received: 4 bytes
Total number of transmit ac- knowledged packets: 4 bytes
Total number of transmit re- transmitted packets: 4 bytes
Note: All data in
Example Command : &0AQ(cr)
Response : !0AQ0A 00 00 00 01 00 00 00 09 00 00 00 1A 00 00 00 05 00 00 00(cr)
The underlined portion of the above response is used to show binary data. In this example: there are 10 packets received, 1 of them is the CRC error, no
29 |