Advantech ADAM-4550 user manual Read Module Name, Uploading

Page 27

4.10. Read Module Name

Description Requests to read the module name from the module at ad- dress AA.

Syntax $AAM(cr)

Response !AA(module name)(cr) if the command is valid

?AA(cr) if an invalid command is entered

Example Command: $0AM(cr)

Response: !0A4550(cr)

4.11. Uploading

Description Requests to upload new firm- ware to the module at address AA.

Syntax $AAL(cr)

Response !AA(cr) if the command is valid

?AA(cr) if an invalid command is entered

After having received ‘!AA(cr)’ response, the host computer starts to send 2 bytes Hi-Lo data length followed by the firmware binary data. If the host receives response ‘?AA(cr)’ or no re- sponse, it will stop sending the binary data.

ADAM-4550 User's Manual

27

Image 27
Contents ADAM-4550 Contents FCC Warning FCC IdentificationFeatures IntroductionBuilt-in Intelligence Page Power Supply InstallationBasic Configuration Factory Default SettingsSoftware Configuration RS-485 Communication WiringConfiguring ADAM-4550 Basic Connection Diagram Pin Assignment Uploading a New Version of Firmware Using the Diagnostics Functions Antenna Installation Using ADAM-4550 115.2 ADAM-4550-S RS-232ADAM-4550-01 Test Sample Syntax ADAM-4550 Command SetConfiguration Mode Commands Data Pass Mode Commands Set New Configuration Command DescriptionsExample Command Write Identification Read ConfigurationSet Delimiter Character Read IdentificationSet Data Gate Read Delimiter CharacterRemain at Open Gate/Write to Flash Read Firmware Version Read Data Gate Status DescriptionResponse ExampleUploading Read Module NameSend Data to Remote Data Pass mode Get Error Rate StatisticsDBi Omni-Directional Antenna Appendix a External Antenna OptionsDBi Grid Parabolic Reflector Directional Antenna Appendix B External Antenna Wiring Diagram