Configuration Mode Commands
Command Syntax | Command Name | Description |
|
|
|
%AANNTTCCFFPP(cr) | Sets new configuration | Requests to set new address, baud rate at module AA |
|
|
|
$AA2(cr) | Reads configuration | Requests to get current configuration from module address AA |
|
|
|
$AA6(ID string)(cr) | Writes identification | Sets the identification data (0 to 16 bytes) to module at address AA |
|
|
|
$AA7(cr) | Reads identification | Reads the identification data from the module at address AA |
|
|
|
$AACD(cr) | Sets the delimiter | Sets the delimiter character (":", "[", "]", "^", "{", "}", "~", "" ) for Data |
|
| Pass mode commands |
|
|
|
$AAD(cr) | Reads the delimiter | Reads delimiter character from the module at address AA |
|
|
|
$AAF(cr) | Reads firmware version | Reads the firmware version number |
|
|
|
$AAM(cr) | Reads module name | Reads the model name of the module |
|
|
|
$AAL(cr) | Starts uploading | Starts uploading of new firmware to the module at address AA |
|
|
|
&AAAD1D2(cr) | Sets Data Gate | Requests the module at address AA to set Data Gate to Open(1) or |
| command | Close(0) |
|
|
|
&AAB(cr) | Reads Data Gate Status | Requests the module at address AA to return Data Gate status |
|
|
|
18 |