Advantech ADAM-4550 user manual Remain at Open Gate/Write to Flash

Page 25

Response:

!0A(cr)

Note: 1. If the command asks the module to

The command asks the module

write to FLASH memory, the status will

remain at Open Gate/Write to FLASH

at address 0Ah to close the data

when the power is turned off and then

gate and not to write to FLASH

on again.

memory.

 

 

 

Command: &0AA11(cr)

2. If the command asks the addressable

module to open the data gate, the mod-

 

 

Response: !0A(cr)

ule will automatically assume non-ad-

The command requests the

dressable mode. This enables the mod-

ule to issue commands without adding

module at address 0Ah to open

{AA until the user issues another com-

the data gate and write to Flash

mand to close the data gate.}

memory.

 

 

ADAM-4550 User's Manual

25

Image 25
Contents ADAM-4550 Contents FCC Warning FCC IdentificationIntroduction FeaturesBuilt-in Intelligence Page Basic Configuration InstallationFactory Default Settings Power SupplySoftware Configuration RS-485 Communication WiringConfiguring ADAM-4550 Basic Connection Diagram Pin Assignment Uploading a New Version of Firmware Using the Diagnostics Functions Antenna Installation Using ADAM-4550 ADAM-4550-S RS-232 115.2ADAM-4550-01 Test Sample Syntax ADAM-4550 Command SetConfiguration Mode Commands Data Pass Mode Commands Set New Configuration Command DescriptionsExample Command Write Identification Read ConfigurationSet Delimiter Character Read IdentificationSet Data Gate Read Delimiter CharacterRemain at Open Gate/Write to Flash Response Read Data Gate Status DescriptionExample Read Firmware VersionUploading Read Module NameSend Data to Remote Data Pass mode Get Error Rate StatisticsDBi Omni-Directional Antenna Appendix a External Antenna OptionsDBi Grid Parabolic Reflector Directional Antenna Appendix B External Antenna Wiring Diagram