RAD Data comm ARC-101 Cable Connections, Installation, Two Units, ATM Connection Control Port

ARC-101Installation & Operation ManualChapter 2. Installation

Installation of	Rack adapter components for installing two units include two short side
Two Units	brackets (for rack mounting) and two flat rails (for fastening the two units
	together)

Figure 2-2 Installation of Two Units

To install two units follow these instructions:

1.Place two units side by side. On the top of each unit are four grooves. The grooves should line up when the units are placed side by side.

2.Place a flat rail on each of the groves in the center of the two units.

3.Fasten the brackets to the units using the 8 screws provided.

4.Place the assembled units in the rack, and fasten the brackets to the side rails of the rack, by means of the two screws situated on each side, as shown in Figure 2.2 (not included in the kit).

2.5 Cable Connections

The ARC-101 has several connectors on its front panel (see Figure 2-3) for ATM connection and connection to an ASCII terminal, and a power connector on its rear panel.

ATM Connection

Control Port

Connection

Figure 2-3 ARC-101 Front Panel

Connect the appropriate cables to the connectors in both modules.

The CONTROL port connector is an RS-232/V.24 RJ-45 connector for an ASCII terminal (9600 baud).

Cable Connections 2-3