RAD Data comm ARC-101 operation manual RAD data communications Headquarters US East US West

Page 1

ARC-101

ATM Rate and Media Converter

Installation and Operation Manual

Notice

This manual contains information that is proprietary to RAD Data Communications. No part of this publication may be reproduced in any form whatsoever without prior written approval by RAD Data Communications.

No representation or warranties for fitness for any purpose other than what is specifically mentioned in this manual is made either by RAD Data Communications or its agents.

For further information contact RAD Data Communications at the address below or contact your local distributor.

RAD data communications

RAD data communications

RAD data communications

Headquarters

US East

US West

12 Hanechoshet Street

900 Corporate Drive

3631 South Harbor Boulevard

Tel Aviv 69710 Israel

Mahwah, NJ 07430 USA

Suite 250

Tel: 972-3-6458181

Tel: (201) 529-1100

Santa Ana, CA 92704

Fax: 972-3-6498250

Fax: (201) 529-5777

Tel: (714) 850-0555

E-mail: rad@ rad.co.il

E-mail: market@radusa.com

Fax: (714) 850-1555

 

 

 

© 1999 RAD Data Communications

Publication No. 334-200-03/99

Image 1
Contents RAD data communications Headquarters US East US West ARC-101Page Warranty Safety Status Ports Safety WarningsRegulatory Information Supplementary Information SafetyContents Operation List of Figures List of Tables General Description Chapter IntroductionInterfaces Supported ARC-101 FeaturesTraffic Management Loopback Mode Specifications RM-1 Ordering ARC-101/#RM-2 Introduction Specifications Unpacking GeneralRack Mounting Instructions Site RequirementsCable Connections InstallationTwo Units ATM Connection Control PortPinout Changing Control Port ModeGrounding AC Power ConnectionARC-101 Modules Module CharacteristicsSC13M/155 Module ST13S/155 ModuleCX/BNC/155 Module ST13L/155 Module12 UTP/155 Module Front Panel UTP/155 ModuleT3 Module E3 ModuleModules E1 and E1/LTUInserting Modules Removing Modules Inserting Removing ModulesFor E1 and E1/LTU Jumper Settings17 T3 Jumper Locations Jumper Settings for T3Installation Name Description Chapter OperationOperating Procedure ARC-101 Block Diagram Operation Introduction Accessing, Using and Exiting Monitor ModeARC Menu Screen Explanations Configuration WindowGeneral Information Window General InformationSystem ConfigurationParameters ALL Changes will be SAVED. are YOU SURE? Y/NLeft Module Right/Left Module ConfigurationAscii Terminal Configuration Ascii Terminal ConfigurationDiagnostics Diagnostics WindowPerformance Monitoring Window Link Status SLM SONET/SDH Link Status WindowLOS LOC OOF AIS RDI BIP Febe T3 Link Status Window Errors/Alarms displayed in Plcp ModeATM Status ATM TrafficE3 Link Status Window E1 Link Status WindowCounter precision is 1/10,000 Software Management Performance Monitoring Window