Eclipse - Fujitsu Ten CD5000 manual Parametric equalizer adjustment PEQ

Various Settings

Parametric equalizer adjustment (PEQ)

The parametric equalizer adjusts 7 frequency bands.

1	Press the [SEL] button to select the band to be adjusted.	… 1 ➔ 2 ➔ 3 ➔ 4 ➔ 5 ➔ 6 ➔ 7 ➔1 …
		1: 63Hz↔80Hz↔100Hz
		2: 125Hz↔160Hz↔200Hz
		3: 250Hz↔315Hz↔400Hz↔500Hz
2	Turn the [SEL] button to select the frequency to be
		4: 630Hz↔800Hz↔1kHz↔1.25kHz
	adjusted.	5: 1.6kHz↔2kHz↔2.5kHz↔3.15kHz
		6: 4kHz↔5kHz↔6.3kHz↔8kHz
		7: 10kHz↔12.5kHz↔16kHz
	Press the buttons to set the slope.
3		[		] : Increases level.
		[		] : Decreases level.
	Press the [6] button to select the Q curve pattern.
4			NORMAL SHARP		SLOW
	Each time the button is pressed, the Q curve changes in the
	following order.

5 Repeat the operations in steps 1 to 4 to change The settings for each band.

6 Hold down a button, [1] to [5], for more than two seconds to preset a value.

The preset value is overwritten by the value set using the above steps.

The time alignment and crossover adjustments will also be stored at this time.

Selecting an equalizer mode from memory

Press a preset button to select the equalizer mode set in memory for the button. The buttons that set equalizer modes in memory are called preset buttons.

1 Select any button, from [1] to [5], and press it for less than two seconds.

The preset pattern stored in memory will be retrieved.

2 Press the [RTN] button.

At this time, other adjustments can also be made in advance mode.

ATTENTION: When the preset value is changed, the display shows as follows:

1-5 Preset ch No.

62