Elmo HV-8000SX instruction manual Connection to the monitor and the projector

Connection to the monitor and the projector

The following settings of the Presenter can be switched with the DIP switch. Switch the settings according to the connection environment. The factory settings are as shown in the following table:

Key	Function	Initial setting
		Key selection	Content
A	To switch the image output	0	SXGA output
B	To switch the TV output method	0	NTSC
C	To switch the TV output screen size	0	Over scan
D	To initialize the network function settings	0	Normal operation

Note: Be sure to turn OFF the power supply to all equipment before making any connections to protect the Presenter and all the connected equipment.

Note: When switching the I/O selection switch key, be sure to turn OFF the power supply to the Presenter beforehand.

Note: Hold the cable plug when connecting or disconnecting the cables.

Connection to the analogue RGB-in terminal

Connect the analogue RGB-out terminal [OUTPUT·RGBOUT] to the equipment having an analogue RGB-in terminal with the analogue RGB cable (attached) or a connection cable available on the market.

At this time, the position of the display may be deviated from the center. If deviated, manually adjust the horizontal and vertical positions on the connected equipment side. Also, vertical stripes may appear on the screen of the liquid crystal projector. That can be alleviated by manually adjusting the dot clock frequency on the projector side.

Liquid crystal projector

AC IN POWER

ON

OFF

DC12VRS-232C

Ethernet USB MOUSE

VIDEO L AUDIO R S-VIDEO RGB OUT

OUTPUT

AUDIO

(L/R)1

RGB1	AUDIO
RGB2
	(L/R)2
INPUT

Monitor

Connection to the composite video-in terminal

Use the supplied RCA video/audio cable or a BNC cable available on the market.

AC IN POWER

ON

OFF

DC12VRS-232C

Ethernet USB MOUSE

VIDEO L AUDIO R

S-VIDEO RGB OUT

OUTPUT

AUDIO

(L/R)1

RGB1	AUDIO
RGB2
	(L/R)2
INPUT

Monitor

- 16 -