Elmo HV-8000SX Connection to the network, Setting up of the network, Ethernet straight cable

Connection to the network

•Connection using HUB

Connect the Ethernet terminal (RJ-45) of the Presenter to the HUB port with an Ethernet straight cable (UTP Category 5). For the HUB port, use a port other than the cascade port.

DC12V RS-232C

Ethernet USB MOUSE

VIDEO L AUDIO R

S-VIDEO RGB OUT

OUTPUT

RGB1

RGB2	AUDIO
	(L/R)2
INPUT	ABCD

Host Host

HUB

Ethernet straight cable

•Connection to one host

Connect the Ethernet terminal (RJ-45) of the Presenter to the Ethernet terminal of the host with an Ethernet cross cable (UTP Category 5).

DC12V RS-232C

Ethernet USB MOUSE

VIDEO L AUDIO R

S-VIDEO RGB OUT

OUTPUT

RGB1

RGB2	AUDIO
	(L/R)2
INPUT	ABCD

Host

Ethernet cross cable (accessory)

Note: Upon connection of this Presenter to other unit on the network through the Ethernet terminal, the communication protocol is adjusted automatically between the Presenter and the connected unit to 10BASE-T/100BASE-TX and HDX/FDX (i.e., “automatic negotiation”). Therefore, this Presenter may not be properly connected to some units on the network that do not comply with automatic negotiation.

Setting up of the network

•Start the Web browser from the host connected to the Presenter.

•Enter the IP address or host name (if allocated) of the Presenter, following [http://], in the address column of the

Web browser provided for entering the URL to be opened. For example, enter the IP address of this Presenter as “http://192.168.0.100/,” since it has been factory set to 192.168.0.100.

•When the HV-800SX/8000SX/ 8500SX page is displayed in the Web browser, click the link [SET UP].

- 37 -