Message | Causes | Corrective Actions |
|
|
|
General failure. | The operating system is | This message is usually |
| unable to carry out the | followed by specific |
| command. | information. Note the |
|
| information, and take the |
|
| appropriate action to resolve |
|
| the problem. |
|
|
|
Invalid | An invalid system | Run the System Setup |
configuration | configuration caused a | program and review the |
information - | system halt. | current settings. See "Using |
please run SETUP |
| the System Setup Program |
program. |
| and UEFI Boot Manager" on |
|
| page 37. |
|
|
|
Keyboard | Faulty keyboard controller; | See "Getting Help" on |
controller | faulty system board. | page 133. |
failure. |
|
|
|
|
|
Keyboard data | Keyboard cable connector is | Reseat the keyboard cable. If |
line failure. | improperly connected or the | the problem persists, see |
Keyboard stuck | keyboard is defective. | "Troubleshooting a USB |
| Device" on page 110. | |
key failure. |
| |
|
| |
|
|
|
Keyboard fuse | Overcurrent detected at the | See "Getting Help" on |
has failed. | keyboard connector. | page 133. |
|
|
|
Local keyboard | The USB ports are disabled | Power down and restart the |
may not work | in the system BIOS. | system from the power |
because all user |
| button, and then enter the |
accessible USB |
| System Setup program to |
ports are |
| enable the USB port(s). See |
disabled. If |
| "Entering the System Setup |
operating |
| Program" on page 38. |
locally, power |
|
|
cycle the system |
|
|
and enter system |
|
|
setup program to |
|
|
change settings. |
|
|
|
|
|
Manufacturing | System is in manufacturing | Reboot to take the system |
mode detected. | mode. | out of manufacturing mode. |
24
About Your System