NCR NCR 5992 manual Supervisor Mode, Startup Sequence

Page 33

Operational Modes

4-3

Supervisor Mode

Startup Sequence

To access the 5992 supervisor mode:

1.The unit must be powered down.

2.Power up the unit and immediately place the stylus in the center of the 5992 display screen. Hold the stylus in this position during the power up as shown in the illustration below.

3.The Supervisor Menu Diagnostics Menu selection screen will display.

Note: If Supervisor Menu or Diagnostics Menu is not selected within 10 seconds, the unit exits this screen and starts the 5992 application.

Center of Display

16840

Image 33

Contents Users Guide Page Table of Contents Troubleshooting Index Iv Users Guide Revision Record Federal Communications Commission FCC Radio Frequency Interference StatementsCanadian Department of Communications Voluntary Control Council For Interference VcciIntroduction OverviewModel Configurations Physical DescriptionSecurity Signature Capture Unit StylusInterface Cable Functional Description Power ModuleEIA-232 Communication InterfaceIBM-EIA-485 Software Products Available SoftwareAvailable Software Unit Location Hardware ConsiderationsPower Considerations Power ModulesAuxiliary Power Cable Environmental Considerations UnpackingInspection Inventory InstallationConnecting the NCR 5992 Stylus Connecting and Disconnecting NCR 5992 Stylus and Host CableConnecting the NCR 5992 Host Cable Disconnecting the NCR 5992 StylusDisconnecting the NCR 5992 Host Cable Cable Configurations Connecting the NCR 5992 to the NCR 7452/3 WorkstationConfiguration Configuration 2 5992 connected to 7452/3 using 120 VAC power 5992-K100-V100 Connecting the NCR 5992 to a PC Installation Installation Operational Modes Normal ModeOperational Modes Startup Sequence Supervisor ModeSelect Supervisor Menu with the stylus or your finger NCR 5992 Supervisor Menu Key Features OperationNavigating through the Menu Items Supervisor Menu Items Menu FlowRead File SystemWrite Enter App # Delete Compress Space Report Init Space Application Configuration ID Banner Change PasswordSerial Number Hardware ConfigurationStart Application Power DownPerforming a Setup Maintenance ModeDigitizer Calibration Screen Contrast AdjustmentEIA-485 Link Address EIA-232Performing Diagnostics What is the ping-pong test?What are tallies? Loading the Operating System Response 00 05 00 ef ea Simple Troubleshooting Guide TroubleshootingFor diagnostics instructions, refer to of this guide Detailed Problem TroubleshootingIndication Action Indication Action Diagnostics Specification Diagnostics Specification Diagnostics Specification NCR 5992 Diagnostics Menu Key Features Menu Flow Keypad Test MSR Test Display TestLrce IBM 46xx Test Test Selection Host RS232 TestBaud Rate Selection Data Bit Selection Parity SelectionAUX1A RS232 Test Baud Rate Selection Select Parity from the AUX1A screen AUX1B RS232 Test Select Test from the AUX1B screen Select Parity from the AUX1B screen Sram Test Security Menu Encryption TestTest Encrypt Dukpt Master/Session Session Key Menu Option Description SecurityEncrypt and Key Check Values Test EncryptIf Dukpt is selected, the NCR Length keys Key Check ValueDisplays key check value for Session Key Canadian Menu Option Description Index SelectSystem Key InjectionDukpt Library Version OS VersionDigitizer Version Security VersionTouch CalibrateTouch the cross with your finger to start finger calibration Diagnostics Specification LCD Contrast Stylus TestShow Touches Show Keypad Touches Base Line/GainDiagnostics Specification Index Index-41 Page B005-0000-1108 Apr Printed on recycled paper