SimpleTech ZeusIOPS manual Power-On Fault Codes, Flash Series Condition

POWER-ON FAULT CONDITIONS

The fault codes listed in Table 37 indicate that a fault has been detected during the power-on sequence. As a result, the unit is in a non-operational state and remedial action is required to replace the unit.

Power-on fault codes are indicated as a series of flashes. The fault light will illuminate for 0.25 seconds (250mS), then turn off for 0.25 seconds (250mS), followed by a 2 second off interval. The number of flashes between each 2 second off period is used to indicate the different fault conditions.

Table 37. Power-On Fault Codes

Flash Series		Condition
1	Flash	Memory strobe adjustment failure.
2	Flashes	Memory address failure.
3	Flashes	Memory data failure.
4	Flashes	ECC error encountered during memory test.
5	Flashes	ECC detection/correction circuit failure.

The fault code should be noted (along with the drive serial number if possible), and either the supplier of the SSD unit or technical support should be contacted.

64 ZeusIOPS 3.5-Inch Fibre Channel Solid State Drive Product Manual Rev. 1.0