SimpleTech ZeusIOPS Certification and Warranty, FCC Declaration of Conformity, Limited Warranty

Page 83

CERTIFICATION AND WARRANTY

FCC Declaration of Conformity

ZeusIOPS Solid State Drives carry the FCC-Mark in accordance with related Federal Communications Commission (FCC)–USA directives. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Modifications made to this device that are not approved by STEC Inc. may void the authority granted to the user by the FCC to operate this equipment.

Limited Warranty

STEC Inc., Solid State Drives are warranted against defects in material and workmanship, and will operate in substantial conformance with their respective specifications under normal use and service for a period of five (5) years from the date of shipment. Subject to the conditions and limitations set forth below, STEC will, at its own option, either repair or replace any defective SSD Product that proves to be defective by reasons of improper workmanship or materials, if buyer notifies STEC of such failure within the stated warranty period. Products repaired or replaced during the applicable warranty period shall be covered by the foregoing warranties for the remainder of the original warranty period or ninety

(90)days from the date of reshipment, whichever is longer. Parts used to repair products or replacement products may be provided by STEC on an exchange basis, and will be either new or refurbished to be functionally equivalent to new.

STEC INC. DISCLAIMS ALL OTHER WARRANTIES, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO ITS PRODUCTS AND ANY ACCOMPANYING WRITTEN MATERIALS. FURTHER, STEC INC. DOES NOT WARRANT THAT SOFTWARE WILL BE FREE FROM DEFECTS OR THAT ITS USE WILL BE UNINTERRUPTED OR REGARDING THE USE, OR THE RESULTS OF THE USE OF THE SOFTWARE IN TERMS OF CORRECTNESS, ACCURACY, RELIABILITY OR OTHERWISE.

STEC Inc. is not responsible for updates or functionality of third-party software. Software is provided with notices and/ or licenses from third parties which govern your use.

Modifications

Any changes or modifications made to this device that are not expressly approved by STEC Inc. will void the user’s warranty. All wiring external to the product should follow the provisions of the current edition of the National Electrical Code.

81

Image 83
Contents ZeusIOPS Fibre Channel Inch Solid State Drive Product Manual Export Administration Regulation Manual Conventions Page Revision Status Summary Sheet Revision HistoryPage Table of Contents Product Description Performance CharacteristicsElectrical Specifications FC-AL Features Interface SpecificationsFibre Channel Standard Physical CharacteristicsEnvironmental Characteristics InstallationContact and Ordering Information Regulatory CompliancePage List of Tables Page List of Figures Page Product ID Code Capacity Approximate ScopeProduct ID Codes Interface Specifications Standard FeaturesPerformance Characteristics Electrical SpecificationsRegulatory Compliance InstallationFibre Channel Standard Reference Documents Download upgrades via the Fibre Channel interface Environmental Characteristics Product Description Performance Characteristics Parameter Value Units Data Transfer RatesStandard DoD 522.22-M Afssi NSA Capacity Minutes Erase TimesCapacity Erase Time Sanitize Times and StandardsUnauthorized maintenance to the SSD will void the warranty Power Consumption Electrical SpecificationsPower Supply Power RequirementsGrounding Fault LED OUT SignalReady LED OUT Signal Selid to Alpa Translation Selid FunctionParallel ESI High Parallel ESI Low SELN/PESIN Signal DefinitionsSFF-8045 Enclosure Service Interface STARTn MatedLink Rate Devctrlcoden Signal DefinitionsDrive Present DevctrlcodexSSD Operation Interface SpecificationsSCA-2 Interface Connector Relative SCA-2 Connector Location Voltage and Ground Signals Pin SCA-2 Connector PinoutOption Support Loop ConnectionsFC-AL Supported Options Command Code Command Name FCP-SCSI CommandsAllocation Length Report Luns CommandBit Byte Operation Code A0h Reserved Select Report Read 6 CDB Read 6 Command 08hTest Unit Ready CDB Code Reserved Allocation Length Control Write 6 CDBBit Byte Operation Code 0Ah Reserved Response Data Format Additional Bit Byte Peripheral Qualifier Peripheral Device TypeDevice-Type Modifier Version Ecma Version ANSI-approved VersionReserved Code Allocation Length Control Mode Sense CDBCode Field Descriptions Parameter List Length Send Diagnostics CDBParameter Pointer Log Sense CommandBit Byte Operation Code ReservedRead Capacity CDB Reserved RelAdr Read Extended 10 28hRead Extended 10 CDB Bit Byte Operation Code 28h Logical Unit number RsvdReserve RelAdr Verify 10 2FhBit Byte Operation Code 2Ah Logical Unit Number Rsvd Buffer Offset Write Buffer Command 3BhBit Byte Operation Code 3Bh Reserved Mode Buffer ID Mode Value DescriptionCode Description Subclause Code Field Descriptions for Mode SenseBit Byte Operation Code 5Ah Reserved Persistent Reserve Bit Byte Operation Code 5Eh Reserved Service ActionBit Byte Operation Code 5Fh Reserved Service Action Command Command Code Description Unsupported Mandatory CommandsFibre Channel Arbitrated Loop Fibre Channel StandardPage Fabric Node Connection Fabric Node ConnectionClosed MonitoringArbitration OpenFCP Level Description FCP Function LevelsFormatted Capacities Physical CharacteristicsGeneral Physical Characteristics ZeusIOPS 3.5-Inch Dimensions Storage Temperatures Environmental CharacteristicsTemperature Conditions Operating TemperaturesComponent Locations Maximum Component TemperaturesComponent Designator Maximum Package Temperature System Requirements InstallationDrive Configuration Flash Series Condition Power-On Fault CodesCode Condition Description Operational Fault CodesBit Bits 5 Configuration Result Selectid ConfigurationsPossible Drive Orientations Suggested Air Flow Patterns for Cooling Underside Mounting Holes Side Mounting Holes Exterior Mounting SpecificationsDrive Installation Microsoft OS Compatibility Operating System SpecificationsWeb Browser SSD Management UtilityZeusIOPS Management Utility Requirements Operating SystemNand Flash Support Restriction of Hazardous Materials Regulatory ComplianceMARKING, Approvals and Supporting Documentation Mark/Approval DocumentationEMI Test Site Correlation Verification TestingRadio Frequency Emissions Radio Frequency Immunity RequirementsAcceptance Criteria Definitions Electrostatic Discharge ESDESD Requirements Acceptance Criteria DefinitionsContact Information Contact and Ordering InformationPage Index Manual Conventions Scope Page Modifications Certification and WarrantyLimited Warranty FCC Declaration of ConformityStec Inc World Headquarters