Intermec PD4 manual Align the media with the center section

Page 33

Chapter 4—Loading Media

Tear-Oﬀ, cont.

9

10

Align the media with the center section
and adjust the label feed guide. Flip the
guide back so it snaps to the rear label	Optionally, press the lower part of the
feed rod and close the printhead.	label taken sensor to ﬂip it open.
11	12

When in use, the label taken sensor
should be in a horizontal position.	Close the side door.

Intermec EasyCoder PD4—User’s Guide

23

Image 33

Contents EasyCoder PD4 Bar Code Label Printer Page EMS and EMI Compliance Statement FCC Notice United States of AmericaIntermec EasyCoder PD4-User’s Guide Contents Adjustments TroubleshootingLoading Media Maintaining the PrinterMedia Speciﬁcations Technical DataBefore You Begin Safety SummarySafety Icons Global Services and Support Warranty Information Web Support Telephone SupportRelated Documents Introduction Description of EasyCoder PD4 Product Identiﬁcation Safety WarningsIntroduction Installation Unpacking the Printer Front View Rear View Media Compartment Print Mechanism Power ConnectionsComputer Control Lamps Controls and IndicatorsDisplay Control KeysKey Functions Mode Feed key Pause key Cancel keyInstallation Starting Up Switching On the Printer Direct Mode Printing a Test Label Loading Media Tear-Oﬀ Straight-through Flip the label feed guide upward Tear-Oﬀ,Rotation of the roll Align the media with the center section Tear-Oﬀ, Peel-Oﬀ Self-strip Screw Peel-Oﬀ,Peel-Oﬀ, Peel-Oﬀ, Thermal Transfer Printing Ribbon Load Ink outside the roll Ribbon Load,Loading Media Printing Controlling the Printing Navigating in the Setup Mode Setup MethodsKey label in display Function in the Setup Mode KeySetting review Setup Options Media TypeDensity SpeedPrinting Intermec EasyCoder PD4-User’s Guide Printing Options Stripper and Internal Rewinder Installation InstructionsSwitch Rewinder cable Cutter Cutter connector Cutter cable Cable clips Options Troubleshooting Error Handling Description/Display MessageAction Printing stops Command errors Error Suggested actionPrintout not in desired position Clearing Media Jam in Cutter Entering the Dump Mode Maintaining the Printer Printhead Cleaning Clean the printhead dot line External Cleaning Printhead Replacement Cut oﬀ any damaged or wrinkled part Media JamsAdjustments Engage the printhead and load the ribbon Printhead Balance AdjustmentPrinthead Pressure Adjustment Printhead Dot Line Position Adjustment Adjustments Label Gap Sensor Position Adjustment Label Gap Sensor Calibration Ribbon Tension Adjustment 1234567890 Ribbon Shield AdjustmentPage For media load Intermec EasyCoder PD4-User’s Guide Technical Data Table of Technical Data Physical Measures Power SupplyEnvironment ElectronicsData Interfaces Media Speciﬁcations Media Roll Size CoreInternal Roll Non-Adhesive Strip Media⇒ Liner Self-Adhesive Strip⇒ Label Length Self-Adhesive LabelsSELF-ADHESIVE Labels Feed Direction Tickets with Gaps Tickets & Tags Feed Direction ⇒ Black Mark Width Tickets with Black MarkTickets With Marks Feed Direction Interfaces RS-232 Interface DB-9 Signal MeaningProtocol Interface CableUSB Interface Pin Function Transmitter Comment Parallel InterfaceFirmware Upgrading Instructions RequirementsPage 960614-01