Dell D08S owner manual Removing the Hard Drive

Page 17

6.Follow the procedures in After Working Inside Your Computer.

Removing the Hard Drive

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a)cover

b)optical drive

c)drive cage

3.Perform the following steps as shown in the illustration: and

a)Press the retention clips inwards [1].

b)Slide the hard-drive bracket out from the drive cage. [2].

4.Flex the hard-drive bracket and remove the hard drive from the bracket.

5.Remove the screws that secure the mini hard drive to the hard-drive bracket and remove the hard drive from its bracket.

NOTE: Perform step 5 only if you have a mini hard drive.

17

Image 17
Contents Regulatory Model D08S Regulatory Type D08S001 Page Contents Diagnostics Before Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerPage Page System Overview Removing and Installing ComponentsRecommended Tools Removing the Cover Installing the Cover Removing The Expansion Card Installing the Front BezelRemoving the Front Bezel Page Removing the Optical Drive Installing The Expansion CardRemoving the Drive Cage Installing the Optical DriveInstalling the Drive Cage Removing the Hard Drive Removing the Speaker Installing the Hard DriveMemory Module Guidelines Installing the SpeakerRemoving the System Fan Installing the MemoryRemoving the Memory Removing the Power Switch Installing the System FanInstalling the Power Switch Removing the I/O Panel Removing the Power Supply Installing the I/O PanelPage Page Removing the Coin-Cell Battery Installing the Power SupplyRemoving the Heatsink Assembly Installing the Coin-Cell BatteryRemoving the Processor Installing the Heatsink AssemblyInstalling the Intrusion Switch Installing the ProcessorRemoving the Intrusion Switch System Board Components Removing the System Board Page Installing the System Board Navigation Keys System SetupBoot Sequence System Setup Options COM1 Video Computrace Service from Absolute Software KEK Performance Post Behavior When Lookup Method is set to Static IP Updating the Bios Clearing Cmos Clearing Forgotten PasswordSystem and Setup Password Assigning a System Password and Setup Password Disabling a System Password Page Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Power LED Diagnostics Troubleshooting Your ComputerBeep Code Error MessagesPage DIMM1 Page Page Technical Specifications Communications Power Page Contacting Dell